|
PULSE AUTOCYCLE NETWORK
|
View previous topic :: View next topic |
Author |
Message |
Bob Hichborn
Joined: 12 Feb 2004 Posts: 404 Location: Orlando, Fl
|
Posted: Mon Aug 09, 2004 7:39 pm Post subject: FRONT END REMOVAL |
|
|
I'm in the process of removing the front end to give it a good overhaul. I noticed Dave Bauer's pictures and notes on an older message board dealing with this procedure. BTW...has any of the valuable info from that old site been transfer to autocycle.org?
So, am I to understand that the two bolts that go into the steering "collar", are what holds the front end on? Does the huge nut on the top of the tube (bearing preload adjuster) have to be removed first. BTW... does anyone know what size that bolt is? I was up at Autozone the other night and wrenches that big are going for $39.95!!!! So, I'd hate to make a mistake and get stuck buying a few of them.
Thanks for any help. This is the last step needed to totally remove the body, so I'm anxious to get the front end off (and do it right). |
|
Back to top |
|
|
Bob Hichborn
Joined: 12 Feb 2004 Posts: 404 Location: Orlando, Fl
|
Posted: Mon Aug 16, 2004 10:23 pm Post subject: |
|
|
Ok, well it seems like this task might be a first for the group, so I'll give you a status, with pictures to follow. I'll give a basic procedure here, but will create of more detailed doc with pictures in the coming weeks.
.5 Strap hoist around main frame and apply lift to get front wheel off the ground.
1. Remove front windshield
2. Remove brake line at top of steering columm
3. Remove brake line at bottom by brake caliper
3.5 Detach speedmeter cable
4. Remove 2 caliper support plate bolts
5. Remove 2 caliper bolts - you'll notice due to clearance issues the caliper can't immediately be removed.
6. Remove 8 left and right side "axle chock" screws
7. Wheel and tire assembly should now "drop" down easily.
8. Back up top, tap the bent metal "locks" from around the two 15/16 main support bolts.
9. Loosen and remove the two bolts and curved steering columm "collar"
10. Steering assembly should drop straight down thru from wheel cavity.
Notes:
- The front steering assembly is heavy, approx. 50lbs without the wheel.
- The VW styled front rim does not have a zero offset, possibly applying more pressure to one side of the front steering assembly? Could account for some portion of the Pulse's balancing issues..
Questions:
- Does everyone have the front wheels that are not zero offset? Look at your front wheel, is the center piece in the center of the outer rim, like a motorcycle or is it "offset" to the left or right of center?
- Is there any reason not to use a "mag" or solid styled motor cycle front wheel?
- If there are any of the original design people "lurking" out there... Is the front axle all custom or did it originate off some other vehicle?
That's it for now......not bad progress, considering it was done in the aftermath of hurricane Charley. Man..... what a mess down here! |
|
Back to top |
|
|
Bob Hichborn
Joined: 12 Feb 2004 Posts: 404 Location: Orlando, Fl
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB 2.0.22-1 (Debian) © 2001, 2005 phpBB Group
|